Standard Snowboard Bevels

September 26, 2014
Standard Snowboard Bevels

The bevel on a snowboard refers to the degree at which the sides and edges are cut. Beveling is advised as part of correct care and maintenance for your snowboard. When done regularly, it assists enhance performance on the slopes by permitting you to turn and slide quickly and successfully. Numerous ski and snowboard shops provide beveling services, and some sell devices for cutting the bevels yourself.

Base Bevels

The base of your snowboard describes the bottom area that comes into contact with the snow. Beveling the base edge of your board makes it easier to rotate as you move down the slope. The standard base bevel is 1/2 to 1 degree, which most snowboard factories utilize as a guide. This degree optimizes speed and grip for recreational snowboarders. Anything higher could cause high speeds and make it tough to control motion, especially for newbies. Beveling service specialists normally stick to this standard, but some will produce custom-made bevels on request. Note that once you set the bevel angle on your snowboard you cannot go back to the initial.

Edge Bevels

The edge bevels of your snowboard are those on the sides of the board. Correct beveling of this area offers improved grip on the snow. The basic angle for edge bevels is 1 to 3 degrees. The lower end of the standard is ideal for newbies and soft snow conditions. Greater edge bevels are appropriate for stronger snowboarders and jam-packed slopes.

Racing Standards

Snowboard racers might do better with higher degrees of beveling on the base and edges of their board. This reduces the quantity of grip on the snow, permitting faster speeds. A racing snowboard may have a base bevel of as much as 2 degrees with edge bevels that range from 3 to 5 degrees.

Tips

Use the producer’s guidelines for exactly how commonly to bevel your snowboard base and edges. This will typically rely on how often you utilize your board and how quickly it wears. SkiMD, a ski and snowboard-tuning business, suggests asking the store that bevels your board to show you that it’s actually accomplished the wanted degree on both the base and edges to make sure proper handling as soon as you hit the slopes. If you decide to bevel your own snowboard, practice the technique on an old board until you acquire self-confidence in the method. If you aren’t sure of exactly what degree of beveling you ‘d such as for your snowboard, take it out for a couple of test runs, which permits you to recognize problems with activity and speed that can be fixed with beveling.